Streaker STL Packs
The Streaker Recon Buggy is an agile, lightly-armored scout vehicle that relies largely on speed to survive. Heavy inspiration came from higher-speed off-road endurance racing vehicles, granting it exceptional mobility over difficult and broken terrain. A number of variants have been created since its introduction, allowing it to keep up with technological advances.
Metal Core Collectibles files are all designed from the ground up with Resin-based 3D printing in mind. The Pack includes both Supported and Unsupported files. Although the supported files are the same as I use for producing my physical stock I simply cannot fully account for all the variables involved with different printers, resins, environmental factors and user practices. Some files will require that holes be carefully drilled using a Pin Vice or other small, manual drill, 'Pilot' marks are provided. When applicable parts will have small marks for where magnets can be installed to help with alignment.
Each of these packs maybe purchased individually, alternatively the "Full Pack" will always contain All Available files. In addition the Full Packs will also be updated in the event that additional variants are added to the Sprinter in the future. If you've already purchased, for example, a 'Streaker STL Battle Pack' and wish to Purchase the Full pack, see the Terms and Services on STLs for information on how to Upgrade at a discount.
Full Pack
All available Variants are included in the Full Pack.
Tactical Pack
BC1/D1 - Rocket Launcher[6]
D3 - Rocket Launcher[2], TAG
R4 - Missile Launcher[5]
Overload Pack
S1 - Rocket Launcher[4], Small Laser x2
S2 - Medium Laser x2, Small Lasers x4
D2 - Medium Laser x3, TAG
Pinpoint Pack
K1 - Light Particle Cannon
BC3 - Rocket Launcher[4], TAG
R2 - Large Laser
Guerilla Pack
R1 - Medium Laser, Sensor Suite
R3 - Flamer x3
R5 - Micro Missile Launcher [10]
Striker Pack
BC2 - Rocket Launcher[4], Medium Laser
D4 -Medium Laser x2, TAG, ECM
R6 - Rocket Pod[20] x2, Machine Gun x2
Hauler Pack
APC - 4Ton Troop Compartment
APCM - MASH suite and Paramedic Equipment
T - 4Ton Cargo Capacity Flatdeck
Notes The Streakers will require a 7/64"(~2.75mm) hole to be drilled into the Turret Bed to fit the peg found on the turrets. A different sized hole can be used if you plan on magnetizing the the turrets and the Turret Bed.
Also Available as a Physical Product for those without 3D Printers!
By downloading this Sampler Pack you are acknowledging you have read our terms and services page located HERE